Ncstar DRGB135 Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 7
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
OPERATION
The Rheostat Knob (3) performs a number of functions. The Rheostat indicator marking is printed
and located on the top of the optic with a White Dot.
There are Numbers and Letters printed on the Rheostat Knob.
The DRGB135 will turn OFF when the Rheostat Knob is set to any of the Letters R,G, or B”. The
Rheostat Knob functions as an ON/OFF switch and brightness control for the Red/Green/Blue Dot
Sight.
The Numbers “1-3” are different brightness settings for the Red/Green/Blue Dot, in which “1” is
the dimmest setting and the higher numbers increases the brightness level of the Red/Green/Blue
Dot. Number “3” is the maximum brightness setting for the Red/Green/Blue Dot.
After you are done using the DRGB135, make sure that the Rheostat Knob is set to Letters “R,G,
or Bin order to preserve battery life.
ZEROING YOUR GREEN DOT SIGHT
ADJUSTING WINDAGE AND ELEVATION:
Your DRGB135 is equipped with adjuster turrets for Windage and Elevation. The Elevation
Adjustment (5) is located on top of the Optic’s Body. First remove the Elevation Cap (4) off the
Elevation Adjustment (5) and use a flat head screwdriver or a coin to make Up/Down Elevation
adjustments.
Twisting the Elevation Adjustment (5) Counter-Clockwise move the Dot Down, and twisting the
Elevation Adjustment (5) Clockwise will move the Dot Up. Replace the cap once you have made all
necessary adjustments.
The Windage Adjustment (7) is located on the right side of the Optic’s Body. First remove the
Windage Cap (6) off the Windage Adjustment (7) and use a flat head screwdriver or a coin to make
Left/Right Windage adjustments.
Twisting the Windage Adjustment (7) Counter-Clockwise will move the Dot to the Left, and twisting
the Windage Adjustment (7) Clockwise will move the Dot to the Right.
NOTE: Each click of adjustment changes the point of impact (where the bullet strikes the target).
This means that the makings on the Windage Adjuster stating L will actually move the Dot to the
right. This also means that the markings on the Elevation Adjuster UP will move the Dot down.
Each click will move the Dot by the amount shown on the chart below.
Windage/Elevation inches of movement per click
25 yards
50 yards
75 yards
200 yards
1/4
1/2
3/4
2
Vue de la page 3
1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire